Confidence behind the first fire
Output matched to the room
We assess heat needs so the appliance isn't chosen on appearance alone.
Flue route considered early
We check the chimney or proposed route before installation is planned.
Openings can be altered
We can prepare or change a fireplace where a simple fit isn't possible.
Plan the stove before fitting begins
A stove has to suit the room, not just the gap in the fireplace. Before a log burner installation, we consider the room size, proposed heat output, existing opening, chimney condition, ventilation and possible flue route. That early assessment helps prevent an oversized appliance making the room uncomfortable or a poor flue arrangement weakening the draw. We can fit into a prepared opening or handle alterations where the fireplace needs opening up. The hearth, connecting pipe, liner or flue, terminal and safe clearances all form part of the system, so we plan them together rather than treating the stove as a stand-alone box.
Correct fitting supports safer daily use
Appliance size and flue configuration influence heat, fuel use, combustion and how well smoke leaves the property. We check the required components, complete the fitting and commission the installed system. Our HETAS Registered Installer status is backed by ten years of experience as a HETAS engineer, giving you informed work around compliance and safe operation. If your Kendal property needs chimney alterations or a new liner as part of the job, we can assess those connected elements before work starts and explain what is needed.
Frequently asked questions
Can you install a stove in an existing fireplace?
Yes, if the opening, hearth, chimney and clearances are suitable or can be altered. We inspect the current arrangement and explain any preparation needed, which may include opening work, a liner, ventilation or changes around the hearth.
How is the right log burner size chosen?
We consider the room, insulation, intended use and safe operating requirements rather than choosing by looks alone. Correct sizing matters because too much or too little output can affect comfort, fuel use and how you operate the appliance.
Does a new log burner always need a flue liner?
Not every project is identical. We assess the existing chimney, appliance requirements, flue dimensions and condition before deciding what lining approach is suitable. Where a liner is required, its diameter, support and termination must suit the full system.